I'd recommend that you use this to load a backup game, and when you're done, return all the settings to normal. Also, it's possible that certain games would be affected. My guess is that if you use RiiConnect24's Wii Mail, it would stop working since it relies on IOS80. I have no idea what side effects changing the System Menu's IOS would have. ![]() In the end, it was all fine, but I still would recommend having BootMii as boot2 + a NAND backup before you try this, since you are messing with the System Menu. I tried this on a Wii without BootMii as boot2. Because we're not replacing any IOS, it's a lot safer. The difference is, rather than replacing every IOS, we're simply making the System Menu use a different IOS than it normally would. This method does do something very similar to what DARKCORP does. So I had found a way to boot burned discs from the Disc Channel without DARKCORP. I started the game, it loaded to the menu, everything was good. Finally, after what felt like an eternity, the discs disappeared, and I was greeted by the wonderful Wii Party banner. The discs on the screen start to spin, and spin, and spin some more. I'm greeted with the familiar Wii and GameCube disc joined by the text prompting me to insert a disc. Be careful, this step could leave you in a brick if you use an IOS that is a stub. ![]() I went back to Priiloader, and while keeping the hack I enabled previously enabled, I went to Priiloader settings, went to "Use System Menu IOS", disabled that, and then set the System Menu IOS to 249. After many seconds of the spinning discs, I got the error we know too well. After that, I went to the Disc Channel and inserted my burned disc. My first experiment was going to System Menu Hacks in Priiloader and enabling the "Force Disc Games to run under IOS249" hack. Now I was ready to begin experimenting on my Wii. Then, I used ImgBurn to burn the ISO to a blank DVD. If you have to do it in chunks, it's not a problem, you'll just have to copy them together later on using Command Prompt. I used CleanRip to rip my Wii Party disc. In order to do that, I had to first legally obtain an ISO. A Wii that has a disc drive that can read DVDs (see )īefore I started experimenting, I needed to actually burn a disc. Turns out, there is! Prerequisites (if you'd like to do this yourself) ![]() Regardless, I decided to go on a quest and do some experimenting to see if there was a better way to accomplish what DARKCORP does. Really, you shouldn't be using DVD backups at all. This is why it's not recommended to install DARKCORP. If the installation messes up, your Wii is once again in a sticky situation. If you have DARKCORP installed, HBC will flip upside down and HackMii installer will refuse to work, and you're in a pickle if you reset your Wii with DARKCORP installed. ![]() In the past, the only solution to run burned Wii games through the Disc Channel was to use either a modchip, which isn't feasible for everyone as it involves opening the Wii and potentially soldering, or something like DARKCORP, which might have worked, but there are a few problems with it: We now have a video tutorial on the Wii part of this method, courtesy of AFK797! You can find it here. Edit: Gave this post a much needed clean up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |